Side-Power SE 60/185 S Bedienungsanleitung PDF herunterladen (Seite 13)

SE 60/185S ignition protected thruster assembly 1.0 - 2007

 Propeller is fastened correctly to the shaft.

 Propeller turns freely in tunnel.

 The zinc-anode holding screw is tightened well with thread glue.

 There is a sturdy additional support under the electric motor, taking the weight load of the electromotor assembly away

from the stern tunnel.

 All electrical wiring, cable sizes and battery capacity is according to the thruster installation manual.

 All bolts are securely tightened and sealant are applied as instructed.

 Anti-fouling have been applied to the gearhouse and propeller but NOT on the zincanode or the gearhouse lid where the

propeller is fastened.

 Correct drive direction as per controlpanel.

 All electrical connections are clean, dry and tight, and the correct cable, fuse and main switch sizes have been used.

 The bolts holding the gearhouse and motorbracket together are tightened correctly.

Very important for IP protection:

 The original O-ring seal between the motor assembly and the motor bracket is present and the bolt tightening procedure is

done.

 The main power cables have securely been connected as described.

 The control lead ends out of the explosive area and has been properly tted and secured against damage.

The thruster has been installed as per the instructions in this manual and all points in checklist above have been controlled.

Signed: ..................................... Date: .......................................

Extra pre-delivery tests by installer / yard who does not use other quality control systems !

Thruster type: ................................................. Voltage: ......................

Serial number: .....................................................................................

Date of delivery: ..................................................................................

Correct drive direction as per controlpanel: .......................................

Voltage at thruster when running: ......................................................

Battery cable size used: .....................................................................

Other comments by installer:

Checklist

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Side-Power SE 60/185 S Bedienungsanleitung Seite 13