Side-Power SEP 100/185 T Wartungshandbuch PDF herunterladen (Seite 172)

911 - 8 Page Date: 4. Februar 2011

Pilot´s Operating Handbook

EXTRA 330LX

Section 911

BECKER ATC 4401 Transponder

2 A permanent test runs in the background of the transponder operation. The built-in FPGA organizes

the required resources for this. The transmitter recognizes a missmatching or own abnormal

behavior and delivers an alarm signal to the FPGA.

3 A further test of the unit is triggered, if the VFR1 button (F) and VFR2 button (G) are pressed

simultaneously. At this test all segments must flash into display (E) as long as the buttons are

pushed. Additional the transmitter and evaluation are tested on correct function in the SBY, ON

and ALT modes.

4 In case of a failure appears the report e.g. 'E10' in the top line of the display. Switch OFF the

transponder at such 'E' fault indications.

911.1.8 CONFIGURATION MODE

The configuration Mode is used to set the unit on the ground and must not be called up in flight.

Refer to BECKER's Pilot's Guide for further information.

911.2 LIMITATIONS

Not applicable.

911.3 EMERGENCY PROCEDURES

911.3.1 IMPORTANT CODES

7600 Loss of communications.

7500 Hijacking.

7700 Emergency (All secondary surveillance radar sites are ready to receive this code at all

times).

See the Airman’s Information Manual (AIM) for a detailed explanation of identification codes.

911.4 NORMAL PROCEDURES

Not applicable

911.5 PERFORMANCE

Not applicable

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 283 284

Keine Kommentare

Side-Power SEP 100/185 T Wartungshandbuch Seite 172