Side-Power SE 60/185 S Bedienungsanleitung

Made in Norway© Sleipner Motor AS version 1.0 - 2007®SE 60/185 S Ignition Protected thruster assemblySIDE-POWERSLEIPNER MOTOR ASP.O. Box 519N-1612 F

10SE 60/185S ignition protected thruster assembly 1.0 - 2007• You can install as many panels as you wish by using optional Y-connectors. If two

11SE 60/185S ignition protected thruster assembly 1.0 - 2007"Visual" wiring diagram 11SP55S2i ignition protected thruster assembly1.1 -

12SE 60/185S ignition protected thruster assembly 1.0 - 2007 12SP55S2i ignition protected thruster assembly1.1 - 2006SLEIPNERSIDEPOWERTHRUSTERSOF

13SE 60/185S ignition protected thruster assembly 1.0 - 2007 Propeller is fastened correctly to the shaft. Propeller turns freely in tunnel.

14SE 60/185S ignition protected thruster assembly 1.0 - 2007 Ensure that you know the location and how to operate the main battery switch and t

15SE 60/185S ignition protected thruster assembly 1.0 - 2007How to use a bowthruster1. Turn main power switch for the bowthruster on. (Always tu

16SE 60/185S ignition protected thruster assembly 1.0 - 20072134» Keep the propeller and gearhouse clean from growth by painting with antifoulin

17SE 60/185S ignition protected thruster assembly 1.0 - 2007Before seeking assistance at the help desk of your Sidepower dealer / distributor ple

18SE 60/185S ignition protected thruster assembly 1.0 - 20071. The equipment manufactured by Sleipner Motor AS (The “Warrantor”) is warranted to

19SE 60/185S ignition protected thruster assembly 1.0 - 2007SE 60/185S IP52SP 30 S2i / SP 40 S2 i/ SP 55 S2i3.7 - 2006SP 55 S2iRef: 12V 24V28. Co

2SE 60/185S ignition protected thruster assembly 1.0 - 2007Technical specications ...

Service CentresSleipner Motor AS • P. O. Box 519, N-1612 Fredrikstad • Norway Tel: +47 69 30 00 60 • Fax: +47 69 30 00 70 • sidepower@sleipne

3SE 60/185S ignition protected thruster assembly 1.0 - 2007Prior to installation, it is important that the installer reads this guide to ensure n

4SE 60/185S ignition protected thruster assembly 1.0 - 2007Fig. 1Bolt on installation of the stern tunnel1. Make sure that there are enough spac

5SE 60/185S ignition protected thruster assembly 1.0 - 2007Boat transom Boat transomStern tunnelGrind off the bolt ange and the gelcoat both ins

6SE 60/185S ignition protected thruster assembly 1.0 - 20071. Try the lower-unit in the tunnel (remove the zinc anode) rst by using the gasket

7SE 60/185S ignition protected thruster assembly 1.0 - 20071. Turn the propeller shaft so that the drivepin (5) is in a horizontal position and

8SE 60/185S ignition protected thruster assembly 1.0 - 20071. Remove the 4 bolts in the motorbracket (Fig 1).2. Use the enclosed template to me

9SE 60/185S ignition protected thruster assembly 1.0 - 2007• Explanation of electrical table - All cable lengths are the total of + and - (to an